11
ENTHERMICS MEDICAL SYSTEMS
O C M / E C 1 5 4 0
bl
0 1 / 0 7
C A R E A N D C L E A N I N G
The cleanliness and appearance of this equipment will contribute considerably to its operating
efficiency. Make certain the cabinet and door gasket are kept free of any debris that may
accumulate. Good equipment that is kept clean works better and lasts longer.
CLEAN THE UNIT REGULARLY:
1.
Disconnect the cabinet from the power source.
2.
Remove all detachable items such as the metal basket and basket rail supports.
Clean these items separately.
NOTE:
Avoid the use of abrasive cleaning compounds, chloride based cleaners, or cleaners containing quaternary salts.
Never use hydrochloric acid (muriatic acid) on stainless steel.
3. Clean the interior metal surfaces of the cabinet with a damp cloth and any mild commercial detergent. Avoid the
use of abrasive cleaning compounds. Rinse surfaces by wiping with sponge & clean warm water. Remove excess
water with sponge and wipe dry with a clean cloth or air dry. Leave doors open until interior is completely dry.
4. Interior can be wiped with a sanitizing solution after cleaning and rinsing. This solution must be approved for use
on stainless steel surfaces. Replace blanket support assembly.
5. To help maintain the protective film coating on polished stainless steel, clean the exterior of the cabinet with a
cleaner recommended for stainless steel surfaces. Spray the cleaning agent on a clean cloth and wipe with the grain
of the stainless steel.
6. Clean the window glass with a standard commercial glass cleaner.
7. Wipe control panel, door vents, door handles, and door gaskets thoroughly since these areas harbor debris.
8. Wipe door gaskets and control panel dry with a clean, soft cloth.
Always follow appropriate state or local health (hygiene) regulations
regarding all applicable cleaning and sanitation requirements.
When removing the basket support, the basket support
should be lifted so that the slot fits over the screw as
shown in the above illustration.
SLOT
SCREW
(Listed as Ordinary Equipment.)
AT NO TIME SHOULD THE INTERIOR OR
EXTERIOR BE STEAM CLEANED, HOSED
DOWN, OR FLOODED WITH WATER OR
LIQUID SOLUTION OF ANY KIND. DO NOT
USE WATER JET TO CLEAN.
S E V E R E D A M A G E O R E L E C T R I C A L H A Z A R D
C O U L D R E S U LT.
WARRANTY BECOMES VOID IF APPLIANCE IS FLOODED.