Toggle Volume Key Punch-through Functionality
By default, “
Vol +/-
” and “
MUTE
” keys are sent to STB
only when the remote control is in STB mode.
Punch-through function for those keys is enabled at
the same time when programming the device code for
TV or AUX. That is:
1. If you program the device code for a TV device, the
punch through function will be configured for TV and
disabled for AUX at the
same time
.
2. If you program the device code for an AUX device, the
punch through function will be configured for AUX
and disabled for TV at the
same time
.
To disable the Punch-through function for those keys, do
the following:
1. Press and hold “
STB
” for 5 seconds, then “
STB
” mode
key backlight will light up.
2. Press “
STB
” key once again, then both “
STB
” and “
AUX
”
mode key backlights will light up.
3. Press “
0
”
NOTE
: When Volume Key Punch-through is enabled
for either TV or AUX, “
Vol +/-
” and “
MUTE
” keys will
not be sent to the STB.
Toggle Channel Up/Down Keys for TV/AUX
Every time you program a new TV or AUX code, by
default, the “
CH UP
” and “
CH DOWN
” keys work
as normal for TV or AUX devices. However, it is possible to
toggle ON/OFF this functionality.
You can enable or disable “
CH UP
” and “
CH DOWN
” keys
for TV or AUX by following the steps below:
For TV mode:
1. Press and hold “
TV
” key for 5 seconds
2. Press “
CH UP
” to enable it; or
press “
CH DOWN
” to disable it.
For AUX mode:
1. Press and hold “
AUX
” key for 5 seconds
2. Press “
CH UP
” to enable it; or
press “
CH DOWN
” to disable it.
6
REMO
TE C
ONTR
OL GUIDE
UR
C 4 (EMEA EDITION)
