URC 4 User’s Guide
Copyright
2012 Entone, Inc. All rights reserved
.
9
v2.5 for URC 4
Chapter
3
3.1
Controlling STB using IR URC
Unlike RF, you do not need to do remote registration in order to use URC 4 to control Janus/Amulet through
IR. The remote comes with Janus/Amulet is IR URC 4. However, you have to program the RF URC 4
comes with Entone Second Stream Kit to use IR mode.
To set the RF URC 4 to use IR to control Janus/Amulet:
1. On the URC 4, press and hold the “STB” button for approx. 5 seconds. The “STB” button backlight will
illuminate. Now the URC 4 is in registration mode.
2. On the URC 4, press “STB” once again. Both the “STB” and “AUX” button backlight will illuminate.
3. Press “0” to set RF URC 4 to IR mode only. The RF URC 4 will not send any RF signal.
The “STB” button backlight on the URC 4 will blink twice to indicate that the setting was successful.
Pressing a key other than “0”, “1”, “2”, “3” or a button is not pressed within 30 seconds, the “STB”
backlight will blink rapidly for 7 times to indicate an error and then extinguish, and the URC 4
registration process will be terminated.
