URC 4 User’s Guide
Copyright
2012 Entone, Inc. All rights reserved
.
12
v2.5 for URC 4
To Program a TV or AUX device
1. Locate the device code for your desired device in the device code table provided in the Appendix. If you
could not find the device code for your device or it does not work after trying the listed device codes for
your device brand, then you can go to the next section to try the auto search procedures.
2. Turn on your device and with media inserted (if applicable).
3. On the remote control, press a device mode key for 5 seconds (i.e., “TV” or “AUX”). The device mode
key will light up.
NOTE:
Use the “AUX” mode key to program control of VCR, DVD player, cable box, satellite set-top-
box and audio device.
4. Enter the four-digit device code for you device. If you perform this procedure correctly, the selected
device mode key backlight will blink twice.
NOTE:
If you enter an invalid device code, the selected device mode key will fast blink 7 times. Device
program mode will be terminated.
5. Aim the remote control at your device and press the “POWER” once. The device should be turned off.
If it does not respond, repeat the above steps.
NOTE:
In the programming mode if no key is received within 30s, the device mode key backlight will
blink rapidly for 7 times to indicate an error and then extinguish, and the programming mode will end.
Toggle Power Key Punch-through Functionality
By default, if the remote control is in STB mode, the URC Power button switches STB off ONLY. To control
the URC Power button functionality to switch off either both the TV and/or STB, do the following:
1. Press and hold the “STB mode key for 5s. The “STB” device mode key backlight will light up.
2. Press “POWER” key once.
3. Either do the following:
a. Press 1 to control both the STB and TV, OR
b. Press 0 to control the STB ONLY
NOTE:
In the programming mode if no key is received within 30s, the device mode key backlight will blink
rapidly for 7 times to indicate an error and then extinguish, and the programming mode will end.
Toggle Volume Key Punch-through Functionality
By default, Vol +/- and MUTE keys are sent to STB only when URC is in STB mode.
Punch-through function for those keys is enabled at the same time when programming the device code for
TV or AUX. That is:
1. If user program device code for a TV device, the punch through function will be configured for TV at
the
same time.
2. If user program device code for an AUX device, the punch through function will be configured for AUX
at
the same tim
e.
To disable the Punch-through function for those keys, do the following:
1. Press and Hold STB for 5 seconds, then STB led will switch on.
2. Press STB key once again, then both STB and AUX led will switch on.
3. Press 0
