URC PLUS User’s Guide
Copyright
2009 Entone, Inc. All rights reserved.
16
V2.3 for URC Plus v3.8
Toggle Power Key Punch-through Functionality
By default, if the remote control is in STB mode, the URC Power button switches STB off ONLY. To control
the URC Power button functionality to switch off either both the TV and/or STB, do the following:
1. On the remote control, press “STB” once to ensure it is in STB mode.
2. Press and hold the “Setup” key until the “STB” mode key backlight blinks twice, then release “Setup”.
The “STB” device mode key backlight will light up.
3. Press “POWER” key once.
4. Either do the following:
a. Press 1 to control both the STB and TV, OR
b. Press 0 to control the STB ONLY
Auto Search Procedures
If your device does not respond to the remote control after trying all devices codes listed for you brand, or if
your brand is not listed at all, try searching for your device code as follows:
1. Turn on your TV or your A/V device.
2. On the remote control, press a device mode key once (i.e., TV or AUX).
NOTE:
Use the AUX mode key to program control of VCR, DVD player, cable box, satellite set-top-box
and audio device.
3. Press and hold the “Setup” key until the selected device mode key blinks twice, then release “Setup”.
The device mode key will light up.
4. Press the “POWER” key once.
5. Aim the remote control at the TV. Press either the “CHANNEL UP” key or “CHANNEL DOWN” key to
do device auto-scan:
a. Press the “CHANNEL UP” key to start searching upward at an approx. 5 seconds interval for each
device code. The TV/AUX mode key will be on and blink every 5 seconds while in the device scan
mode.
NOTE:
In this search mode, the remote control will send IR codes from the library starting from the
lowest code set number to the end of code set for that device;
OR
b. Press the “CHANNEL DOWN” key to start searching downward at an approx. 5 seconds interval
for each code set. The TV mode key will be on and blink every 5 seconds while in the device scan
mode.
NOTE:
In this search mode, the remote control will send IR codes from the highest code set number to
the beginning of code set of that device.
6. If the TV turns off, a working code has been found. Press OK once to lock in the code. The selected
mode key will blink twice
7. If all code sets of that device is exhausted in the search and the OK is not pressed, the selected device
key will fast blink 7 times and the search mode will be terminated.
NOTE
: During the auto-scan, you can press “UP” arrow or “DOWN” arrow to advance to the next device
code immediately without waiting for 5 seconds. You can also use “UP” arrow or “DOWN” arrow to change
the direction of the search.
