26
IP2128EN - 2015-05-06
6.1 Preliminary checks
6. Installation
The given operating and performance features can only be guaranteed with the use of ENTREMATIC
accessories and safety devices.
Unless otherwise specified, all measurements are expressed in mm.
Check that the structure is sufficiently rugged and that the hinge pivots are properly lubricated.
Provide an opening and closing stop.
Position tail bracket [14] on to the pillar to check installation measurements and secure it.
The installation measurements indicated in the table allow you to choose the values of [A] and [B] on
the basis of the desired opening angle and in relation to the on site spaces and overall dimensions.
NOTE: The measurements [A] and [B] must be the same, in order to have a regular moviment.
Increasing [A] decreases the coming up speed during opening.
Reducing [B] increases the extent of gate opening.
Measurements [A] and [B] must in any case be compatible with the useful travel of the piston so
that; if [A] is increased, [B] must be decreased and vice versa.
A
D
E
L
min 60
B
C
[*] Use measurements between minimum and maximum values
A*
B*
A
B
C
D
E
L
LUXO3B
LUXO3BH
min 105
max 160
min 130
max 170
130
170
100
90°
90
760
105
140
70
90°
130
130
60
95°
160
130
50
110°
LUXO4BH
LUXO5B
LUXO5BH
LUXO5VBH
min 130
max 200
min 170
max 290
170
170
100
90°
120
910
200
200
130
95°
200
170
100
120°
130
290
220
90°