30
IP2253EN - 2017-01-10
After selecting the most suitable point for fastening the front bracket [18] to the gate wing, to
establish its height you must first size, position and fasten the rear bracket [17].
If necessary, shorten the rear bracket [17] following the indications given in Tab. 6.1.
-
Once you have fastened the rear bracket [17] following the measurements given on page 12,
fasten the front bracket [18] to the gate.
-
With the gate fully closed, position the front bracket [18], respecting the measurement (L).
Make sure the front bracket [18] and rear bracket [17] are properly levelled, as shown in the
figures below, then fasten the front bracket [18] to the gate.
6.2 Fastening the brackets
L
17
18
