ENTRON PROGRAMMING TOOLS
NetFlash™
78 |
P a g e
Copyright © 2021 BF ENTRON and/or its affiliates. All rights reserved
Product Model:
iPAK2v2
Firmware Version:
V2.10
May 22 | Doc No 700253-2
4.1.9.1
Building the network table
The Network table is build using the following icons.
Icon
Name
Description
Edit Control
Description
Allows the description of a control already in the table to be edited. Click on the control to be edited then
click on this tool.
Add A Control
Adds a new control to the table
Delete a Control
Deletes a control from the table. Click on the control to be deleted then click on this tool.
Scan Network for
Controls
The scan tool will search the connected network and report a list of controls found. To assist with
identification, both the IP address and MAC number are reported.
Click on any control in the list then click
OK
to set it as the
Target IP address.
Change IP
Address in
Control
Allows the IP address in the target control to be changed. Don’t forget to change the NetFlash™
Target IP
address
if you subsequently wish to access the control with its new IP address
Set Control as
Target
A control may be selected by first clicking on it in the table, then clicking on this tool.
The Target IP address
box on the main screen status bar will be updated.
Ping Target IP
Address
Performs a low-level communications test on the target control. Use this tool to confirm that the target
control is physically connected to the network.
Table 16: NetFlash Network Window Icons
