ADVANCED FEATURES
Valve Delays
189 |
P a g e
Copyright © 2021 BF ENTRON and/or its affiliates. All rights reserved
Product Model:
iPAK2v2
Firmware Version:
V2.10
May 22 | Doc No 700253-2
9.10.1
Programming Valve Delay Parameters using NetFlash
Example 1
:
The AUX valve outputs can be programmed to activate after the start of any interval. In this example, NetFlash is used to
program AV8 to come on 100 ms after the start of the main heat interval:
Figure 64: Example 1 NetFlash Program Valve Delay Selection Parameters
Figure 65: Example 1 Weld Program Forge Valve Delay Time Parameters
The resulting output is shown below in
Figure 67
.
