ENTRON PROGRAMMING TOOLS
NetFlash™
80 |
P a g e
Copyright © 2021 BF ENTRON and/or its affiliates. All rights reserved
Product Model:
iPAK2v2
Firmware Version:
V2.10
May 22 | Doc No 700253-2
4.1.10.1
Edit window tool-bar
The Edit window Tool bar has the icons defined in
Icon
Name
Description
Load from
Control
The user interface and data are loaded from the control at the Target IP address. NetFlash
™
has a Cache
function which it uses to avoid repeatedly downloading interfaces which it has used before, thus speeding
up loading.
Load From File
The user interface and data are loaded from a previously saved file.
Save To Control
This tool is available after the Load from file function was used. It transfers all data items to the control at
the Target IP address. Can be used as part of a backup/restore process, or for transferring settings to
anther control.
Save to File
Saves the interface and all data to a file on the PC. A browsing window will open and you will be prompted
for a file name and location. Can be used as part of a backup/restore process, or for transferring settings to
anther control.
Open/Close
Metrics Window
The Metrics window shows key information about the status of the target control, such as measurements
and error messages. The window is floatable and may be resized and dragged to any place on your display.
Clicking this tool alternately opens and closes the Metrics window.
The
button on the Metrics window may be used to send a
Fault Reset
command to the target
control.
Copy Programs
etc
Copies a full set of parameters from one program to another, or from one electrode to another. You will be
prompted for the source and the range to be copied to:
Export
Parameters to
CSV file
Data is exported to a file on the PC, in csv format (Microsoft Excel compatible). You can customize which
data is included by checking the boxes:
Click on the icon to open a browser window to set the file name and location.
Table 17: NetFlash Edit Window Icons
