PROGRAMMING WELD PROGRAMS
Weld Program Types
99 |
P a g e
Copyright © 2021 BF ENTRON and/or its affiliates. All rights reserved
Product Model:
iPAK2v2
Firmware Version:
V2.10
May 22 | Doc No 700253-2
Parameter <<< OPTIONS >>>
Value
Program Inhibit:
NO
Pre-Heat:
NO
Post-heat:
NO
Pulsations:
3
Link:
NO
Repeat Mode:
NO
Force Profile:
NO
Retry:
OFF
C-Monitor:
OFF
C-Monitor:
OFF
Table 30: Pulsation Spot Weld Time Diagram Weld Options
The timing sequence follows the order of operations defined below:
1)
Pre-squeeze and squeeze time for the actuator to reach the desired weld force.
2)
An upslope pulse is used to ramp the weld current to the main current in a controlled manner
3)
The first pulse of the main current is applied
4)
A cool is applied
5)
The second pulse of the main current is applied
6)
A second cool is applied
7)
The third pulse of the main current is applied
8)
A downslope current is applied to ramp down the current in a controlled manner
9)
A hold is used to allow the weld nugget to cool while still under force
10)
The End of Sequence (EOS) Output is generated when the sequence is complete.
Figure 29: Pulsation Spot Weld Timing Diagram
