Pixel Octo User Manual
For latest version visit:
www.enttec.com
10 December 2019
M-files ID: 4836041
Page|
10
Wave Amplitude
This setting determines the brightness of each
pixel in a period of the wave.
DMX fader
value
Brightness of Pixels in One Wave Period
0
Vary between 50% and full
255
Vary between off and full on.
Wave Length
This setting determines the number of pixels in
one period of the wave.
DMX fader value
Wavelength
0-1
2 pixels
2-255
Fader Value
Wave Speed
This setting controls the speed at which the wave
pattern travels across tape.
DMX fader value
Speed
0
Minimum speed
255
Maximum speed
Offset
Offset allows the pattern on a port to be delayed.
Editing a Standalone Show
Octo allows the editing of any saved standalone.
Please follow these steps to edit a standalone:
1.
Select the standalone to be edited and click on
Edit button
2.
Select an output to preview the standalone on
by using the check boxes
4.
Edit the standalone
5.
If the standalone previewed is to be preserved,
click on Save Effect button
Deleting a Standalone
Select the standalone to be deleted and press on
Delete button
The standalone selected for each output will
continue to play unless it is deleted; in this case,
the standalone directly above will be enabled at
the output, which had the deleted show. If there is
no standalone above, no standalone will be output.
If a slot without a standalone is deleted the
following message is displayed:
