Quick Start Manual
50687 (NC)
for more information visit:
www.enttec.com/e3
Choose or browse the firmware file (as per your browser)
and click on Update firmware to start the process.
The Status led will blink red during firmware mode.
The update progress is shown in real-time, and will take a
few seconds for the update to complete
When the update is complete, the page will refresh and
you will be taken to the home page – where you can
verify the firmware version. If the update fails for any
reason, please try the same process again.
Since, Ethergate Mk3 will reboot after a firmware update,
please allow a few seconds for it to be refreshed in the
browser. Please wait until the update process is complete.
Reset button
The reset button restores the network configuration of
the Ethergate Mk3 to factory defaults:
•
DHCP is set to enabled
•
Static IP address is mapped to the Serial number
of the unit (used if DHCP is unavailable).
For example, a Serial No. of 2176541 will have a
default Static IP address at 10.17.65.41
•
Netmask is set to 255.0.0.0
To successfully reset to factory defaults the Ethergate
Mk3, the following procedure must be performed:
•
Power off the unit
•
Press and hold the Reset button.
•
While holding the Reset button, power up the
unit, and keep holding the button for 3 seconds.
•
Release the Reset button once the status led
starts blinking red.
•
Wait 3 seconds and cycle power
Art-Net Send Test
NMU can also be used to troubleshoot the DMX output on
your Ethergate Mk3. Art-Net Test can be accessed from the
top menu: Art-net Art-net
→
Test
When first opened, the Art-Net is set to Disabled, please set
it to Enabled, and then you can use either the DMX faders to
test one or more DMX channels, or use the test-patterns
from the options available. Please set the Ethergate Mk3 to
be output and on the same universe as being used to send
Art-Net from NMU.
DMX Connector pin out
5pin DMX OUT/ DMX IN
:
•
Pin 1: Ground
•
Pin 2: Data -
•
Pin 3: Data +
•
Pin 4: NC
•
Pin 5: NC
Any suitable 3 to 5pin DMX adaptor can be used to connect
to 3pin DMX cables or fixtures. Please note the pinout,
before connecting to any non-standard DMX connector.
5
