For safety check details, refer to this manual, section 3 Safety instruction and EC
Directives.
Only qualified person can carry out the following works.
During the process of using the EnverBridge, the manage person shall examine and
maintain the machine regularly. The concrete operations are as follow.
1. Check the EnverPortal website to confirm if the screen in the EnverBridge is normal
or not. This check should be performed at least every 6 months.
2. Check if the cables are damaged or aged. This check should be performed at least
every 6 months.
3. Check for dust or debris. It there’s dust and or debris on EnverBridge, clean it lightly
by brush or vacuum the unit to remove dust particles, which may cause components
inside overheat.
Before cleaning the EnverBridge:
Wear gloves and safety glasses.
Disconnect the EnverBridge from the Grid – Isolating device.
Clean the EnverBridge with wet cloth carefully.
Introduction
Use the monitoring website EnverPortal developed by Envertech to monitor the
statistics information of the energy harvest for all Envertech micro-inverter system
and monitor per-module’s performance which is integrated into the Envertech
micro-inverter system.
Register address
：
http://www.envertecportal.com/LoginPage.aspx
Account Registration
Register Successfully, enter into the page below
：
8.3 Internet WEB
8.2 Maintain periodically
NOTE
The NOTE symbols in this manual indicate the
important product information.
WARNING
Be aware that only qualified personnel should
troubleshoot the PV array or the Envertech
Micro-Inverter.
WARNING
Never disconnect the DC wire connectors
under load. Ensure that no current is flowing
in the DC wires prior to disconnecting and turn
off the AC breaker.
17
18
