9
ASSEMBLY AND USE
WARNING:
Unplug the Four Seasons
™
unit
prior to filling the tank with water
PREPARING FOR OPERATION
1. Open the packing box and take out the
Four Seasons
™
unit.
2. Turn the unit upright for operation.
3. To remove the humidifier wick frame, press
the release tab and pivot the frame outwards
and then lift it out of the unit.
See Figure 1.
NOTE: You must remove the wick frame
before you can remove the tank.
4. Remove the tank by sliding it out of the unit.
See Figure 2.
5. Fill the water tank with clean water to
maximum water level marking on tank.
CAUTION: Do not overfill the tank.
Use extreme caution to ensure that water is
poured only into the water tank and that the
rest of the unit stays dry. Never plug in the
unit if it gets wet.
6. After filling, put the tank back into the main
body and replace the humidifier wick frame.
WARNING: This heater is equipped with a
temperature limiting thermostat. If the unit
should sense an overheat condition, the
element will stop heating. It can only resume
operation when user manual reset the unit.
TO RESET HEATER: Unplug the unit and
wait 10 minutes for the unit to cool down,
then plug unit back and follow the “USING
THE FOUR SEASONS
™
” instruction described
in this manual.
Figure 1
Figure 2
Summary of Contents for Four Seasons FS200
Page 1: ...Owner s Manual ...
Page 2: ...2 ...
Page 3: ...3 INSTRUCTIONS FOR USE 4 MODE D EMPLOI 14 ...
Page 24: ...49977 02 ...
