3
4
1. Control panel
2. Humidifier water sensor
3. Humidifier wick frame
4. Wick frame release tab
5. Water tank
6 Air inlet grill
7. Humidifier wick
8. Air outlet grill
9. Fan speed switch
10. Refill light
11. Humidifier
12. Humidifier only
13. Heater only
14. Function knob
15. Power button
16. Heater knob
pROdUCT OVERVIEW
9
CONTROL pANEL
10
11
12
13
14
16
15
7
8
1
4
3
6
5
2
ASSEMBLY ANd USE
WArNINg:
Unplug the HumidiHeat
™
unit prior
to filling the tank with water
pREpARING FOR OpERATION
1. Open the packing box and take out the
HumidiHeat
™
unit.
2. Turn the unit upright for operation.
3. To remove the humidifier wick frame, press
the release tab and pivot the frame outwards
and then lift it out of the unit.
See Figure 1.
NOTE:
You must remove the wick frame
before you can remove the tank.
4. Remove the tank by sliding it out of the unit.
See Figure 2.
5. Fill the water tank with clean water to maxi-
mum water level marking on tank.
CAUTION:
Do not overfill the tank.
Use extreme caution to ensure that water is
poured only into the water tank and that the
rest of the unit stays dry. Never plug in the
unit if it gets wet.
6. After filling, put the tank back into the main
body and replace the humidifier wick frame.
WARNING:
This heater is equipped with
a temperature limiting thermostat. If the
unit should sense an overheat condition, the
element will stop heating. It can only resume
operation when user manual reset the unit.
TO rESET HEATEr: Unplug the unit and wait
10 minutes for the unit to cool down, then
plug unit back and follow the “USING THE
HumidiHeat
™
” instruction described in
this manual.
Figure 1
Figure 2
