1. Remove the unit from its box.
2. Open the door by first removing the cover with the nameplate
attached (open valve door and pull nameplate cover side tab to
release catch). Undo the two bolts at the bottom of the door.
Lift the door up and out to remove. Caution: glass may separate
from door.
3. Remove log and ember set and all wrapping material from the
stove. Remove wrapping material from log and embers and
check for any damage. If damage is observed, do not use unit
and contact your local dealer.
4. Measure the distance from the front of the fireplace facing to
the front of the flex liner in the chimney.
5. Remove the front exhaust locating screw. Slide the exhaust
channel backwards from the unit. Properly secure the exhaust
channel to the 3” flexible vent pipe liner previously installed in
the chimney using Mil-Pac around the opening and three (3)
evenly spaced sheet metal screws. Be careful not to over-stretch
the liner.
6. Place the unit part way into the fireplace. Connect the fireplace
insert’s rigid gas line to the household gas supply using locally
approved methods. Place the electric cable so it can be
connected to the power supply. Adjust the leveling legs.
7. Slide the insert into the fireplace, ensuring that the exhaust
channel is located under the slide rails on the top of the fireplace
insert.
8. Re-install the locating screw and tighten.
9. To assemble the surround panel, lay the panel face down on
a soft flat surface and place the brass trim on the surround
panel, using the corner brackets to hold the trim to the surround
panel.
10. Connect the surround panel wire harness terminal to the stove
wire harness terminal on the right side panel.
11. Place the assembled surround panel around the fireplace then
align the slots with the screw heads. Push back then down to
engage the surround slots on the mounting screws. Make sure
the top surround panel sits flat on the stove.
Initial Installation
QUALIFIED INSTALLERS ONLY
P
REPARATION
F
OR
I
NSTALLATION
:
• Remove the packaging from the appliance and surround panels, check to make sure there is no
damage. Carefully check the glass door.
Do not use the unit if it is damaged.
In the event damage is
found, please report it to your courier and/or your dealer as soon as possible.
• Carefully clean the fireplace and flue before installing the stove. Failure to do so may result in fumes or
dirt being blown into the room and may cause a fire leading to serious injury or death.
A
SSEMBLING
A
ND
I
NSTALLATION
I
NSTRUCTIONS
:
�������� �����
�������� ����
Figure 5. Preparation for Installation.
Figure 6. Surround Installation.
12
