21
t
he
t
ube
S
craper
r
od
:
Put the stainless steel rod through the hole in the heat exchanger located behind the top louvers. Thread
the rod into the scraper plate, which is visible from inside the firebox by removing the top baffle.
o
ptional
S
lider
/d
amper
r
od
& k
nob
i
nStallation
:
NOTE: NOT APPLICABLE FOR GERMANY.
If you wish to adjust the slider damper externally (NOT REQUIRED), please follow the instructions below.
This is used to regulate the airflow through the pellet stove.
1. Remove the slider rod (short rod with knob and nuts) from their package and open the left side
panel.
2. Remove the knob and outer nut from the knob. Push the rod through the hole in the slider. Place the
lock nut on the rod and tighten, leaving a
1
/
32
” (1 mm) gap between the slider and the other nut.
3. Make sure the slider moves freely. Close the side panel and tighten screws after placing the rod
through the panel. Screw the knob onto the slider.
Place non-locking
nut on rod
Place lock nut
and tighten
Non-locking nut
Slider
Side panel
Push through
the side
Rod through
panel
Figure 35: Slider / damper assembly.
Installation
t
hermoStat
i
nStallation
:
1. Install the wall thermostat (millivolt rated thermostat recommended, or a 12/24 Volt rated thermostat
set to millivolts) in a location that is not too close to the unit but will effectively heat the desired area.
2. Connect the thermostat or Timer using an 2 x 18 gauge wire from the unit to the thermostat.
If the unit has been placed in the HI / LOW mode,
the unit will be taken to a low or idle setting when
the thermostat is not calling for heat. When the
thermostat calls for heat, the unit will go to the
setting that is displayed on the control board Heat
Indicator. If the heat in the room becomes to great,
the high limit switch may turn the stove off and
the switch will have to be manually reset. To reset
the high limit switch, remove the right cabinet side.
The switch is found behind the control panel. Avoid
setting off the high limit switch.
Figure 34: Thermostat wire placement.
