10
Operating Instructions
b
LoweR
sPeeD
:
The blower will come on only when the fireplace is up to temperature (approximately 15 minutes). The
speed of the fan can be changed by turning the fan control knob. The blower will continue to operate
automatically after the unit has been shut off (approximately 25 minutes).To turn the blower off, turn
the knob COUNTER CLOCKWISE until it “clicks” off (Figure 6).
It is advisable not to operate the blower below
1
/
3
speed as it puts a strain on the windings of the blower
and running the blower at lower speeds could also cause premature fan failure.
n
oRmaL
s
ounDs
D
uRing
o
PeRation
:
Table 1: Normal Sounds
Component
Sound & Reason
Berkeley
Creaking when heating up or cooling down.
Burner
Light pop or poof when turned off; this is more common with LP units.
Temperature Sensor
Clinking when it senses to turn the blower on or off.
Pilot Flame
Quiet whisper while the pilot flame in on.
Blower / Fan
Air movement that increase and decreases with the speed of the blower. The
blower is pushing the heat from the fireplace into the room.
Gas Control Valve
Dull click when turning on or off, this is the valve opening and closing.
Maintenance And Service
R
outine
m
aintenance
:
At least once a year, run through the following procedures to ensure the system is clean and working
properly. Check the burner to see if all the ports are clear and clean. Check the pilot to make sure it is not
blocked by anything. The pilot flame should be blue with little or no yellow on the tips.
Warning:
Clearances must be sufficient to allow access for maintenance and service
Warning:
Failure to position the parts in accordance with this manual, or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
The venting system must be periodically examined; it is recommended the examination is done by a
qualified agency.
c
Leaning
D
ecoRative
s
uRfaces
:
Painted, powder coated, or porcelain enameled surfaces should be wiped with a damp cloth periodically.
Never clean the face when it is hot. Do not use other cleaners as they may leave a residue, which can
become permanently etched into the surface.