13
12
Maintenance And Service
b
uRneR
R
emovaL
:
The burner may need to be removed for a few reasons, including cleaning under the burner, converting
the unit to a different gas type, or to replace the burner altogether.
Proceed only when the unit has
completely cooled down.
Figure 13. Removing Burner.
1. Remove the cabinet front, and glass door as outlined
in the
M
aintenance
and
S
ervice
- G
laSS
d
oor
r
eMoval
.
2. Remove the log set as shown in S
econdary
i
nStallation
- l
oG
S
et
i
nStallaion
3. Place your hands in the air slots in the burners, as
shown in figure 14, then pull forward and lift up to
dis-engage the venturi tubes.
4. Continue to lift up and rotate the burner approx. 45
degrees, as shown in Figure 15, and remove it from
the firebox. Take care not to damage the edges of
the ceramic burner as it is fragile.
To re-install the burner follow steps 1-4 in reverse. When placing the burner back in the unit make sure
it is properly seated and up against the intake plenum at the rear of the firebox. When installed correctly
the burner will have no side to side movement.
Figure 14. Burner Removal - Correct Hand
Placement
Figure 15. Burner Removal - Rotate 45 degrees