51
Secondary Installation
Figure 67: Glass Bezel with Vermiculite Bed
Figure 68: Glass Pebble Bed
9. If you are using 50-3333 (Black Glass Media) or 50-3331 (Light Kit) you may now cover the entire media tray
in a thin layer of glass pebbles; one layer is all you need.
10. You have now successfully installed your panels and media base. You may now arrange your
optional 50-3336 (Log Set); see instruction sheets for further detail.
IMPORTANT: IF THE AIR SLOT AROUND THE BURNER IS BLOCKED WITH MEDIA THIS
WILL CAUSE THE FIREPLACE NOT TO BURN PROPERLY.
AIR
AIR
AIR SLOT
Figure 69: Burner Side Cross Section
7. If you have media tray option 50-3332 (Glass Bezel) place the bezel strips around the tray before the side
liners are installed. If you are using 50-3333 (Black Glass Media) or 50-3331 (Light Kit) install tray media after
the side liners.
8. Place the side liners into the side channels of the media tray. 50-3328 (Ledgestone) and 50-3329 (Enameled)
will be placed in at the bottom and rotated up until seated. 50-3326 (Fluted) will be placed in at the rear and
rotated inward until seated. Once seated secure the top with the retainers using a T-20 Torx screwdriver. If using
50-3332 (Glass Bezel) pull the sides in so they butt up with the long strips.
Summary of Contents for C34I
Page 55: ...55 Parts Diagram 1 2 3 5 4 10 8 7 9 12 13 14 6 11 15 ...
Page 57: ...57 Notes ...
Page 58: ...58 Notes ...