52
Secondary Installation
L
og
s
et
i
nstaLLation
:
The placement of the logs is not arbitrary. If they are positioned incorrectly, the flames can be “pinched”
and will not burn correctly. Using the pictures provided, carefully set the logs in place.
NOTE: The logs are
fragile and should be handled gently.
1.
Position the first log in the back left corner; the log will butt up to both the side and rear panels. Place
the second log into the back right corner; the log will butt up to both the side a rear panels.
2. Position the arched log over top the burner; there should be 3 points of interest when aligning this
log. Make contact with the left liner, the rear liner, and the firebox edge opening. Next, position the camel
toe log against the rear log using the alignment pin. It is important to position the low point of this log on
top of the media tray and not in the burner pan.
3. Slide the whale shaped log under the arched log aligning the 3 points parallel with the firebox edge as
shown. Next, position the diagonal log using the alignment pin and rest it down butt up to the whale log.
Summary of Contents for C44I
Page 55: ...55 Parts Diagram 13 14 6 11 5 3 10 1 2 12 12 9 7 8 11 9 8 13 4 7 10 15 ...
Page 57: ...57 Notes ...
Page 58: ...58 Notes ...
