48
NO MEDIA IN THIS AREA
p
aneL
anD
m
eDia
i
nstaLLation
:
1. Remove the safety screen and glass door
2. Place your burner media into the burner pan (vermiculite or glass media). Create a thin layer that
evenly covers the entire burner pan; pat it down gently.
If flame looks uneven with overly high or
low sections the media can be adjusted. If flame is too high make media thicker, if low thin
media out�
WARNING: Be sure there is no media in the protected pilot area of the
burner pan.
Figure 64:
Protected Pilot Area
Secondary Installation
3. Wear clean vinyl gloves when handling 50-3685 (Fluted) and 50-3686 (Ledgestone) to prevent skin
contact with the refractory. Wear clean vinyl gloves when handling 50-3687 (Enameled) to prevent
smudging; use denatured alcohol to clean. Unwrap your new Enviro liner set from the protective
packaging. Be careful not to scratch or bump the liners as they are very fragile. If the liners arrive
damaged please contact your nearest Enviro dealer.
4. Remove the 3 liner retainers from inside the firebox, loosen screws using a T-20 Torx screwdriver. The
retainers are key slotted so they can be removed without removing the screws. Then remove the existing
steel liners starting with the sides first.
Summary of Contents for C72I
Page 55: ...55 Parts Diagram 1 2 3 4 5 6 9 7 8 12 13 14 10 15 15 ...
Page 57: ...57 Notes ...
Page 58: ...58 Notes ...