23
Initial Installation
Surround Assembly
The surround needs to be assembled be on site.
you will need a
7/16” socket or wrench.
1.
Lay down protective material where you
intend to assemble surround. Carefully unwrap
all parts making sure not to scratch the paint.
2.
Line up surrounds parts aligning the corners
3.
Place the Sandwich plate over the studs.
4.
Using a 7/16” socket thread the nuts onto the studs.
Tighten the nuts down onto the sandwhich plate
DO NOT OVERTIGHTEN THE NUTS.
5.
Align the holes on the Safety screen
with the holes on the surround sides.
6.
Thread the screw through the hole from
the safety screen side to the surround side.
7.
Thread on the nut to the screw. Do not fully
tighten down the nut, as this will hinder the movement
of the screen. Leave the nut loose approximately
halfway down thread, so the door can swing open.
Installing surround onto unit
To install surround on unit.
1.
Open the safety screen.
2.
Lift safety screen and surround, lining up
hooks with slots on the side of the cabinet.
3.
Ensure the surround is hooked into the same
position on both top and bottom hooks.
