8
November 2011
Built In Heater (non-chimney) Flue Kit (54)
Each 54 Built-in-Heater Flue Kit
(non-Chimney installation) contains:-
y
ti
t
n
a
u
Q
n
o
i
t
p
i
r
c
s
e
D
o
N
t
r
a
P
Galvanised outer liner
ø100mm x 900mm long
Stainless steel inner liner
ø75mm x 900mm long
Inner/outer flue liner spacer
Ceiling thimble ø107mm hole
Rain cap 75mm
Rain cap 100mm
Elbow 45° – ø75mm stainless
– black (painted)
T-adaptor/cleanout – ø75mm
This flue kit may be used in new or existing timber
chimneys. The overall height of the flue is 3.6m.
Kit is supplied in a carton.
Note:
The Davin 54 Built-in-Heater Flue Kit
(non-Chimney) complies with AS/NZS
2918:2001 as per Applied Research Test
Report 05/1185, dated 15 September 2005.
All fires must be installed by a qualified
installer as per the manufacturer’s
instructions and AS/NZS2918:2001.
600mm from
roof
penetration
Built-in-Heater Flue Kit
(non-Chimney installation)
54
To order :
December 2006
4
4
2
1
1
1
1
1
1
2
5
6c
8
9
10b
12
50mm minimum clearance if lined flue
150mm
(minimum)
Heat-resistant
floor protector
Seismic restraint
(to be fitted)
Telephone 0800 765 431. Fax 64 3 341 8057 info@switchenergy.co.nz www.switchenergy.co.nz
Drawing representative only - not to scale.
