5
November 2011
External Standard Flue Kit (51)
Each 51 External Standard Flue Kit contains:-
y
ti
t
n
a
u
Q
n
o
i
t
p
i
r
c
s
e
D
o
N
t
r
a
P
1
Galvanised outer liner
ø100mm x 900mm long
2
Stainless steel inner liner
ø75mm x 900mm long
5
Inner/outer flue liner spacer
6w
Wall thimble – 2 pieces
ø102mm holes
6s
Soffit thimble ø107mm hole
7w
Wall decor plate
ø102mm hole – white
8
Rain cap 75mm
9
Rain Cap 100mm
26
Lined T-adaptor
This flue kit may be used in new and replacement
applications with the flue penetrating the wall behind
the fire, running vertically up an outside wall and
penetrating the soffit. The overall height of the f lue is
3.6m. All visible flue has a galvanised finish, and can be
powdercoated on request. Kit is supplied in a carton.
Note:
The Davin 51 External Standard Flue
Kit complies with AS/NZS 2918:2001 as per
Applied Research Test Report 05/1185, dated
15 September 2005.
All fires must be installed by a qualified
installer as per the manufacturer’s
instructions and AS/NZS2918:2001.
Heat-resistant
floor protector
Seismic restraint
(to be fitted)
600mm from
roof penetration
100mm
(minimum)
150mm
(minimum)
External Standard Flue Kit
51
4
4
2
1
1
1
1
1
1
To order :
December 2006
Telephone 0800 765 431. Fax 64 3 341 8057 info@switchenergy.co.nz www.switchenergy.co.nz
Drawing representative only - not to scale.
This flue kit may be used in new and replacement
applications with the flue penetrating the wall
behind the fire, running vertically up an outside
wall and penetrating the soffit. The overall
height of the flue is 3.6m. All visible flue has a
galvanised finish, and can be powdercoated on
request. Kit is supplied in a carton.
