TOOLS REQUIRED:
●
11
/
32
”
socket or wrench
REMOVAL OF DOOR COVER:
When stove is off and cool, open the door. Remove the four (4)
#8 hex nuts around the inside of the glass retainer shown in
Figure 38.
Remove door cover from door by gently sliding the studs out of
the holes. If it is difficult to remove the cover, the glass retainer
may be pinching the threads on the studs. Slightly loosen the
four (4) screws (by each of the studs).
REPLACEMENT OF DOOR COVER:
Slide new door cover into place and hand tighten the four (4)
#8 hex nuts around the inside of the glass retainer. Ensure the
four screws are also hand tight and close door.
Clean all plated surfaces before starting the stove.
See
C
leanIng
p
lated
s
urFaCes
in
r
outIne
C
leanIng
and
m
aIntenanCe
in the
Owner’s Manual.
Figure 38: Inner side of Meridian door.
p
LateD
D
ooR
i
nStaLLation
:
TO AVOID PERSONAL INJURY DO NOT REMOVE OR REPLACE COVER WHEN PELLET STOVE IS HOT!
Door must be open. The three (3) arrows in Figure 37 point to
three (3) of the nuts that hold the louvers on. There are three
nuts on each end. Remove the six nuts by hand; if the nuts are
tight, a
11/32
” socket can be used. When removing the louvers,
pull one end of the louver up over the stud. If it is difficult to
remove the louver, push on one side from the front, then pull
the other end off the second stud.
REPLACEMENT OF LOUVER BAR SET:
Place one slotted end of new louver over a stud, then slide the
other slot over the corresponding stud; replace the nuts and
hand tighten. Close door when all three louvers are replaced.
Clean all plated surfaces before starting the stove.
See
C
leanIng
p
lated
s
urFaCes
in
r
outIne
C
leanIng
and
m
aIntenanCe
in the
Owner’s Manual.
Figure 37: Door with louvers.
Installation
25