24431
Rev. A
10/12
http: www.networketi.com
Environmental Technology, Inc.
55 of 94
Automatic Air Dehydrator
ADH
®
SIROCCO™
Instruction Manual
4.
If the configuration settings have been locked, you will be prompted at this
time to enter the passcode for the Edit Cfg function. If you are prompted
for the passcode, press the rocker switch as described below to enter the
Operational Settings screen. Within 5 seconds of seeing the passcode
prompt, enter the passcode as described below. Wait no longer than 2
seconds in between pressing the switch each time.
Press the upper edge of the rocker switch 3 times;
then press the middle of the rocker switch 1 time;
then press the lower edge of the rocker switch 3 times.
Now, repeat the pattern.
Press the upper edge of the rocker switch 3 times;
press the middle of the rocker switch 1 time;
press the lower edge of the rocker switch 3 times.
As described above, you will press the rocker switch a total of 14 times.
The passcode will be accepted 2 seconds after the lower edge of the
rocker switch is pressed for the last time.
NOTE
If you should happen to select an option which requires or is protected by
a passcode and you didn’t mean to select whichever option prompted the
passcode request, wait a few seconds, press nothing, and the display will
“time out” then return to the previous screen.
5.
Once you have successfully entered the passcode, you will see the same
system settings you saw under the View function but this time, they will be
highlighted for selection. Refer to Figure 70.
Figure 70. THE OPERATIONAL SETTINGS SCREEN.
UNIT English
LALM
0.15
LLIM 0.30
HLIM 0.50
HLRM 1.50
Hum Sensor
Y
Keep Cancel
Low Alarm
Low Limit
High Limit
High Alarm
These are
the factory
default
settings.