24431
Rev. A
10/12
http: www.networketi.com
Environmental Technology, Inc.
60 of 94
Automatic Air Dehydrator
ADH
®
SIROCCO™
Instruction Manual
5.
The top line of the Alarms screen, DCycl, will already be highlighted.
Press the middle of the rocker switch again to narrow the highlight to just
the actual value rather than across the entire line. At this time and before
you actually change the setting, it is assumed that you know why you want
to change the setting and to what percentage you wish to change it. Due
to the unique nature of every system, there is no “best” setting and, thus,
we cannot recommend what your Duty Cycle setting “should” be. It is,
however, very strongly suggested that if you don’t know why or what it is
you wish to accomplish by changing the setting, then don’t change it.
6.
To go ahead and actually change the Duty Cycle setting, use the top or
bottom of the rocker switch, respectively, to increase or decrease it. If you
want the system to indicate system changes to you before a larger
problem develops, consider decreasing the 50 percent Duty Cycle default
setting to, for instance, 15 or 20 percent. This is still well above what the
actual Duty Cycle should be and will indicate any system changes you
should know about. Allowed values, in percentages, are 0 to 99. Once
the setting has been made as desired, press the middle of the rocker
switch to enter the new value, and the entire line will again be highlighted.
NOTE
If you make a mistake and don’t want to keep the change(s) you just
made, scroll down to highlight the Can(cel) option at the bottom of the
screen, press the middle of the rocker switch to select it and cancel the
changes you just made, then repeat the change process.
7.
Once the change is made as desired, scroll to highlight Keep, then press
the middle of the rocker switch to select it. Refer to Figure 78.
Figure 78. THE EDIT ALARMS SCREEN.
DCycl
50
SCTim 01
Alrm3Sel
Keep Can