24431
Rev. A
10/12
http: www.networketi.com
Environmental Technology, Inc.
63 of 94
Automatic Air Dehydrator
ADH
®
SIROCCO™
Instruction Manual
4.
On the Function screen. scroll down to highlight Alarms, then press the
middle of the rocker switch. You will see the Edit Alarms screen. Refer to
Figure 84.
Figure 84. THE EDIT ALARMS SCREEN.
5.
The top line of the Alarms screen, DCycl, will already be highlighted.
Scroll down to highlight SCTim, then press the middle of the rocker switch.
Press the middle of the rocker switch again to narrow the highlight to just
the actual value rather than across the entire line. At this time and before
you actually change the setting, it is assumed that you know why you want
to change the setting and how you wish to change it. Due to the unique
nature of every system, there is no “best” setting and, thus, we cannot
recommend what your Short Cycle Time setting “should” be. It is,
however, very strongly suggested that if you don’t know why or what it is
you wish to accomplish by changing the setting, then don’t change it.
6.
To go ahead and actually change the Short Cycle Time setting, use the
top or bottom of the rocker switch to increase or decrease, respectively,
the Short Cycle Time setting. If you want the system to indicate system
changes to you, then consider observing the “normal” frequency of its
cycling time then consider setting the new value at half or 3/4 of the
“normal” cycling frequency. This setting will indicate to you any system
changes you ought to know about. Allowed values are 01 to 60 seconds.
Once the setting has been made as desired, press the middle of the
rocker switch to enter the new value.
NOTE
If you make a mistake and don’t want to keep the change(s) you just
made, scroll down to highlight the Can(cel) option at the bottom of the
screen, press the middle of the rocker switch to select it and cancel the
changes you just made, then repeat the change process.
DCycl 50
SCTim
01
Alrm3Sel
Keep Can
Expressed
in seconds;
allowed
values are
01 to 60.