24431
Rev. A
10/12
http: www.networketi.com
Environmental Technology, Inc.
93 of 94
Automatic Air Dehydrator
ADH
®
SIROCCO™
Instruction Manual
10.
Once the alarm relay cable is connected and the enclosure access holes
are properly sealed, close and secure the enclosure using the fastening
latches. Make sure the latches snap into position to make sure they are
fully closed and secured.
11.
Finally, once installation is complete, turn the facility circuit breaker back
on and verify that the installation was successful. The unit will make a
vibrating sound when the pump is operating.
CONFIGURING THE UNIT
Now that the unit is installed, it is necessary to configure the specific values and
performance parameters for your specific unit, installation, or location. Refer
back to the section entitled Configuring the System, starting on page 30 in this
Instruction Manual. Once the unit has been configured, verify that the system
pressurizes and is running at a Duty Cycle of less than 20%.
