Copyright EnvironmentalLights.com
All Rights Reserved 10/1/18
3
Operation
1.
Confirm the output voltage of the power supply (12 or 24VDC) is the same as the
required input voltage of the LED strip lights before connecting power.
2.
Consult the wiring diagrams for specific instructions when using greater than 30A
total.
The positive side of the power supply should be split across several terminals to
evenly distribute the current and prevent overloading of the terminal blocks.
Wiring for Under 30A:
•
Make sure the power supply is turned off while wiring the decoder.
•
Connect the 12-24V DC power supply to the “DCV-” and “DCV+” terminals. Make sure
to observe correct polarity.
•
Connect the positive LED wire(s) to the “LED+” terminals.
•
Connect the negative side LED wires to the terminals marked “R”, “G”, “B” and “X” for
red, green, blue and white. Refer to the DMX Address section below for more
information.
Figure I: Wiring Diagram for Under 30A
