Copyright EnvironmentalLights.com
All Rights Reserved 10/1/18
2
Applications
•
High capacity DMX lighting applications requiring 1, 2, 3, 4 or 5 output channels.
•
On-camera applications requiring high PWM frequency.
Specifications
Dimensions:
2.9” x 6.5” x 1.5”
74 mm x 164 mm x 39mm
Output Channels:
1-5
Input voltage:
12-24 Volts DC
Max. current load:
5x8A
Max. output power:
480W/960W (12V/24V)
PWM frequency:
500-30,000Hz
Wiring
1.
Confirm that the power supply voltage matches the LED voltage and that the power
supply is unplugged.
2.
Connect the LEDs and power supply to the
DMX-5-8A
using the screw terminals. Power
supply positive and ground should be connected to “V+” and “GND” terminals
respectively. LED positive should be connected to the “+” terminal. The V+ terminals
may also be used for LED positive if extra space is needed. Connect LED negatives to
output channels 1-5 as appropriate for the installation.
3.
Power up the power supply. The screen will display
where “XXX” is the
DMX starting address.
4.
Connect the DMX input and output (if applicable) to any of the input/output ports. Note:
do not send DMX signals to the decoder while it is powered down.
