Copyright EnvironmentalLights.com
4
All Rights Reserved 1/16/19
Specifications
Part Number
DMX512-PX-V2
Dimensions
4.92” x 2.05” x 1.57”
125 mm x 52 mm x 40mm
Output
V+, DATA, GND
Input Voltage
5/12/24 VDC
Max. Current Load
1x12A
Max. Output Power
60W/144W/288W (5V/12V/24V)
Max. Device Temp
-22 to 150°F (-30 to 65°C)
*Note: The 12A limit does not apply to power supplies directly connected to PixelControl lights
Features
•
Converts Standard DMX512 signals to a control signal compatible with all PixelControl
products. Decodes up to 512 DMX channels for individual control of 170 pixels.
•
Powered by 5-24 VDC.
•
DC+ terminals are connected. Use one for supplying power to the decoder and the other
power powering PixelControl lights, up to 12A.
•
Built in functional test modes. For dynamic
modes (color step and color fade), speed is
controlled by toggling the dip switches 1-5.
**Please read page 8 about DIP Switch 10
before using the functional test mode with
RGB PixelControl Strip Lights.
•
XLR3 and bare wire DMX in and out.
•
DIP switches on the side allow you to set
the decoder’s lowest address so it uses the
address you desire from your DMX
program. Each decoder has a DMX device
address you can set. Default setting with all switches OFF = 1.
DIP switches to set address
**Please note: An address bit is set ON and has a value = 1 in the down position
Applications
•
Enables DMX control of PixelControl LED lighting to create bright animated effects for
studios, stage lighting, architectural, or decorative purposes.
DIP
Mode
1
Red
2
Green
3
Blue
4
Yellow
5
Magenta
6
Cyan
7
White
8
Step mode - speed control 1-5
9
Fade mode - speed control 1-5
