Copyright EnvironmentalLights.com
6
All Rights Reserved 1/16/19
Wiring Instructions
Below is a circuit diagram that illustrates how to wire the DMX512 PixelControl Decoder to
PixelControl lights, a power supply and the DMX controller. In this diagram the Easy Stand Alone
DMX controller is used to control the PixelControl LED lights, but you can use any console that
outputs standard DMX. Keep signal lines away from power lines to avoid inductive coupling and
signal corruption. Be sure to match the voltage of the driver to the required voltage of the
PixelControl lights. This driver is 5V because the RGB PixelControl Strip Lights shown below
require 5V.
Wiring the LEDs to decoder
To connect your LEDs to the DMX512-PX-V2 decoder, please follow Steps 1-3 and refer to the
figure below for terminal locations.
1.
Connect the input data on the PixelControl lights to the output data signal terminal (DATA) on
the decoder.
2.
Connect the ground input on the PixelControl lights to the ground (GND) terminal on the
decoder.
3.
Connect the power input on the PixelControl lights to the power output (DC+) terminal on the
decoder.
