Copyright EnvironmentalLights.com
All Rights Reserved 10/20/13
2
Operation
Use 12 VDC or 24 VDC, depending on your lights. Controller accepts either, and generates
maximum output voltage equal to the input voltage. Apply voltage using the 2.1mm jack at the
side, which is compatible with our adapters and power cords, or use the terminal blocks provided
for bare-wire power connection.
The four output lines (red, green, blue cathodes and common anode) are available on a terminal
block, so use bare wires to connect your lights. Power and signal lights on the controller indicate
and display if the controller is receiving power and/or signal transmissions.
Output and power terminal block
2.1 mm jack DC IN port
Remote control functions:
: Power on/off.
: Toggles between the pre-programmed modes.
or
-: Increases or decreases the speed of dynamic modes.
or
: Increases or decreases the brightness when in static modes (12 levels).
: Indicates signal transmission when green.
RGB1 RF touch sensitive remote
