Copyright EnvironmentalLights.com
All Rights Reserved 10/20/13
5
Circuit Diagrams for Controllers
Detailed wiring instructions for our LED linear lights are available in “rgb_manual.pdf.” Ask for
it, if you haven’t seen it.
Small Scale Installation Using
RGB LED Touch Controller
RGB strips,
superflat rope,
or modules
Do not exceed the product's
(2 wires, +V & ground)
specified branch length limit.
Do not exceed the power rating
of the lowest-rated
driver, amp or controller.
When powering superflat rope, use
24 volt components.
Do not mix 12 and 24 volt systems,
except at the DMX level. (You may
put both 12 and 24 volt decoders on
the same DMX output.)
RGB LED Touch Controller
(4 wires: red, green,
blue, common)
RGB1
12 or 24 VDC Driver
