Copyright EnvironmentalLights.com
All Rights Reserved 10/20/15
10
Plug-In Power Adapter Controller: solar-adapt-ir
1.
Connect the power adapter to the 2-pin connector cable by
aligning the pins to the slot and the hole of the power adapter. The
opposite end of the 2-pin connector cable will connect to the
Christmas Lights.
2.
Install the Solar Christmas Light Strings with any desired splitters
and extension cords to the adapter using the 3-pin screw
connectors. Align the key before connecting the male and female
connectors together.
3.
For all 3-pin connections, screw on the cap to seal the connection
and protect from weather damage.
4.
Confirm that all connections are screwed on tight. This includes the connections between
the controller and the Strings, between each 100 Christmas Strings, between any other
connectors such as 3-way splitters, T-connectors and extension cables.
5.
Plug in the power adapter controller into a 120 VAC outlet.
6.
Press ON located on the IR remote. Choose a time each day/night that
is desired for the Christmas lights to turn on. Wait until the chosen
time, then press TIMER ON from the remote. This will now begin
and repeat the 24-hour cycle: Lights will stay on for 6 hours, then turn
off for 18 hours.
7.
Press any of the numbers 1-8 on the remote to choose the lighting
mode. These are listed on page 2. If the timer is used, the same
lighting mode will automatically turn on each day. Note: If power
being supplied to the adapter is disconnected (ie. power adapter is
unplugged from the outlet), the memory function will restart and the
lights will revert to Mode 8.
