Copyright EnvironmentalLights.com
All Rights Reserved 10/20/15
9
Plug-In Power Adapter Controller: solar-adapt
1.
Connect the power adapter to the 3-pin connector cable by
aligning pins 0, 1 and 3.
The opposite end of the 3-pin
connector cable will connect to the Christmas Lights.
2.
Install the Solar Christmas Light Strings with any desired
splitters and extension cords to the adapter using the 3-pin
screw connectors. Align the key before connecting the male and
female connectors together.
3.
For all 3-pin connections, screw on the cap to seal the
connection and protect from weather damage.
4.
Confirm that all connections are screwed on tight. This includes the connections between
the controller and the Strings, between each of the 100 light strings, and between any
other connectors such as 3-way splitters, T-connectors and extension cables.
5.
Plug in the power adapter controller into a 120 VAC outlet.
6.
Press the button on the adapter until the desired mode plays. The
lighting mode can be changed at any time while the lights are on
by pressing the button to move through the 8 different modes.
These are listed on page 2.
7.
To keep the memory function on and have the lights play the last
mode set, turn the lights off by disconnecting the light strings
from the power adapter.
Note: If power being supplied to the adapter is disconnected (ie.
power adapter is unplugged from the outlet), the memory function
will restart and the lights will revert to Mode 8.
