D4K Pro® User Manual
D4K_UserManual_v1.3_EN.docx, 2021-02-12
Page 17 of 52
6.2
Main Printer Components
6.2.1
Material tray
Also known as Tilting material tray, or Tilt tray. It comprises of two main parts - a film and
a frame. Below the tilt tray assembly is a glass plate. The glass plate stays in position in
the printer, below the tilt tray, at all times. Below the glass plate is the protective cover.
The protective cover keeps the printer’s internal components clean. The protective cover
extends out in front of the tilt tray and is visible during normal operation.
For more information, refer to the
Install the Tilting Material Tray
sections of this User Manual.
6.2.2
Build platform
Also known as Build Plate, Build tray, Printbed, it is the surface of the D4K Pro printer on which
the 3D printed part is formed.
For more information, refer to the
sections of this User Manual.
6.2.3
RFID Tag Reader
The software is written utilizing the very latest RFID technology (Radio Frequency Identification). This helps keeping track of the
lifetime left on the material.
It also does not allow usage of a material that doesn’t match the buildstyle or RFID tag.
Place the RFID card that comes with your material into the clips on the reader, where it is read and processed by the printer to
ensure accuracy.
Figure 4: D4K Pro tilting material tray
Figure 5: D4K Pro build platform