D4K Pro® User Manual
D4K_UserManual_v1.3_EN.docx, 2021-02-12
Page 33 of 52
Tap
Settings |Job settings
to open the tab.
The following settings are available:
•
Check Image
:
function of image verification.
o
[Yes]
- all layers of the job are checked before starting the job.
o
[No]
- the layers are not checked before starting the job.
•
Shutdown at the End:
shutdown of the printer when the job is finished.
o
[Yes]
- the printer turns off automatically after completion of the job.
o
[No]
- the printer does not turn off after completion of the job.
•
Use Compensation Mask:
function of mask application.
o
[Yes]
- the mask is applied to the projected image.
o
[No]
- the mask is not applied to the projected image.
•
Auto Exposure Debris:
function of automatic exposure of the material tray to make cleaning the material tray easier.
o
[Yes]
- the material tray is automatically exposed after the job has failed.
o
[No]
- the material tray is not exposed automatically when the job has failed. In this case, you can manually
perform the material tray exposure after the completion of the build process.
•
Use DLP Table:
function of DLP table application.
o
[Yes]
- the DLP table is used.
o
[No]
- the DLP table is not used.
8.7.1
Manual Debris Removal
This tab allows you to simplify the process of cleaning the material tray.
If for some reason you need to remove debris from the material tray, proceed as follows:
1. Tap
Settings | Manual Debris Removal
to open the tab.
2. Set the required exposure time using the
plus
and
minus icons
.
3. Tap
[Expose]
.
→ The whole
material tray area has been exposed.
4. Remove debris from the material tray by simply taking off the thin film of exposed material.
5. Proceed following the step-by-step for
, if needed.