Page 4 of 5
Mounting possibilities
The EL-10-30-C is compatible with C-Mount lens fixtures. Alternative mounting options include:
G024503000, LINOS
G061042000, LINOS
KM200V/M, Thorlabs
NT03-676, Edmund Optics
http://www.qioptiq-
shop.com/
http://www.qioptiq-
shop.com/
http://www.thorlabs.de/
http://www.edmundoptics.com/
Exchanging the offset lens in the EL-10-30-C
The EL-10-30-C is shipped with a planar cover glass or with an integrated offset lens (MV version), which is held
in place by a retainer ring. The cover glass or offset lens can easily be exchanged by hand following the proce-
dure outlined below. Please note that this is preferably done in a clean room or under a flow hood to avoid
dust entering the tunable lens.
1.
Loosen the retainer ring carefully with a small screw driver
2.
After about 5 rotations turn the lens with the ring pointing down so no dust can get into the lens
3.
Take out the cover glass / offset lens with the retainer ring. Prepare the new cover glass or lens.
4.
Turn the lens again, but be careful, that no dust gets inside. Carefully drop the new cover glass or lens
(planar side should usually look down towards the lens) inside using tweezers.
5.
Put the retainer ring in by hand
6.
Tighten the retainer ring with a screw driver. Be careful not to scratch the glass.
IMPORTANT: At the end, do not exert much torque (<1 Nm) as this might damage the tunable lens.
1
2
3
4
5
6
www.envision.co.kr
(주)앤비젼
서울시 금천구 가산동 550-1 IT캐슬 1동 603호 (153-768)
Tel.
02. 2624. 5503
Fax.
02. 2082. 6427
e-mail.
sales@envision.co.kr
www.envision.co.kr
•Supporting your Vision
