3
CAUTION:
• The NYX-14 is a precision electron-optical instrument, and must be handled carefully at all
times to prevent damage to the device and danger to the user.
• To protect the intensifier tube,
do not remove
the lens cap of the NYX-14 when the monocu-
lar is being operated in daylight conditions, or when the device is not in use.
• Use of the NYX-14 in brightly lit conditions may damage the unit’s intensifier tube.
• Bright light sources such as firelight, headlights, searchlights, etc. can damage the NYX-14.
Avoid exposing the unit to these types of light sources.
• Before removing the lens cap, verify that the photoreceiver is open.
• DO NOT forget to open the photoreceiver after completing your mission.
• DO NOT attempt to force the controls past their stopping points, as this may cause damage
to the mechanisms.
• The unit may be badly damaged if the tripod on which it is mounted collapses or overturns.
Remove the unit from the tripod if it is not within your reach.
• Before replacing the intensifier tube, confirm that it is no longer covered by warranty.
• Thoroughly dry each component of the NYX-14 before placing them in the storage case.
NOTES:
• The equipment requires some ambient light (moonlight, starlight, etc.) to operate.
• Performance of the device in nighttime conditions depends on the level of ambient light in
the environment. Please remember the following:
— The level of ambient light is reduced by the presence of clouds, shade, or objects that block
natural light (trees, buildings, etc.).
— The equipment is less effective when operated in shadows and other darkened areas.
— The equipment is less effective when operated in rain, fog, sleet, snow, dust or smoke.
— The equipment will not “see” through dense smoke.
• At operating temperatures below -20°C (-4°F), the use of an alkaline battery is not recom
-
mended, as the battery life will be severely reduced. Under said conditions, lithium-iron disul-
fide 1.5V AA batteries or their equivalent should be used.
• The IR illuminator is intended for increased illumination, as needed, when viewing at a close
distance of up to 3m.
• For the purpose of returning defective components, retain all packaging materials.
