EN-28
Installation and Operating Instructions - EOS Zeus S / EOS Zeus SL
EN Installation
Installing the heater guard rail
1
Unscrew the 3 cap set screws (
A
) from the fixing holes in the outer cas-
ing.
The set screws (
A
, hex M10) plug the openings for the heater guard
rail brackets.
2
Insert the 3 hex screws (M8 x 40 mm) (
B
) from the inside into the holes.
Screw on the screw bushings (
C
) from the outside and tighten.
3
In the middle of the front side, push on the retaining sleeve (
D
) until it
stops.
The sleeve's large hole must face outward.
A
Cap set screws
B
Hex screws M8 x 40 mm
C
Screw bushing Ø 20 x 40 mm
D
Retaining sleeve
E
Pre-mounted small plate
1x
3x
A
D
E
C
D
C
B
