EOS Farblichtmodul Assembly Instruction Manual Download

Page: 3 / 7

Mounting of coloured light module

(ArtNr. 942761)

in control unit EMOTEC HCS 9003

Please open the control unit just as described in the assembly instruction.

clamps for
supply lines

Fig 2

Fig. 3

pin border

Fig. 4

Please establish the electrical connection.

- The power supply line for the coloured

light module (longish wire) should be
connected with the clamps below the
transformer.

- The outgoing lines (shortish wire) should

be insert to the attached terminal. The
correct order of the wires has to access
to following colours (fig. 3):
N - red - yellow - green - blue

lease insert now the coloured light module
on to the plug border.

(blue)

red yellow green blue

Summary of Contents for Farblichtmodul

Page 1: ...1 GB Druck Nr 29343325en 43 06 Assembly instruction Farblichtmodul GB ...

Page 4: ...e appliance of coloured light modules in the instruction of the appropriated control unit EMOTEC HCS9003 DC9000 Fig 6 Please press the mounting nib into the inside with a flat screwdriver Pivot the upper part to open it Open the control unit Remove the safety spinner Remove the both safety spinner À and Á with a screwdriver The preparing for the instruction À Á Fig 7 ...

Page 5: ...nnection Connect the plug socket of coloured light module with the pins of the plug at the mainboard fig 9 and 11 Fig 9 plug socket double pole pins Connect the coloured light module to the spacers with the 3 mounting screws Mounting of coloured light module Fig 10 mounting screws ...

Page 6: ...e appropriate socket at the mainboard see fig 6 Install the clamp plate Reinstall the clamp plate It must be catched into the 4 pins of the plug Fig 11 pins Fig 12 masked Impress the safety spinner Impress tight fit the both safety spinners again À Á Fig 13 ...