EOS Farblichtmodul Assembly Instruction Manual Download

Page: 7 / 7

Connection of cable

Please connect the cables with the upper
clamps sequential from left to right
according to the clamps inscription.

N - red- yellow - green - blue

Fig. 14

Mounting of coloured light
appliance

Fig. 15

Connect the coloured light appliance with
those clamps which are marked in the
figure according to the clamps inscription.

Please regard the connection schema at
fig.1.

Maximum allowable light power: 100 W

Close the upper cover

Please close the upper cover.

Fig. 16

Starting up

Please find the appliance of coloured light
modules in the instruction of the
appropriated control unit HIC 75.

Summary of Contents for Farblichtmodul

Page 1: ...1 GB Druck Nr 29343325en 43 06 Assembly instruction Farblichtmodul GB ...

Page 4: ...e appliance of coloured light modules in the instruction of the appropriated control unit EMOTEC HCS9003 DC9000 Fig 6 Please press the mounting nib into the inside with a flat screwdriver Pivot the upper part to open it Open the control unit Remove the safety spinner Remove the both safety spinner À and Á with a screwdriver The preparing for the instruction À Á Fig 7 ...

Page 5: ...nnection Connect the plug socket of coloured light module with the pins of the plug at the mainboard fig 9 and 11 Fig 9 plug socket double pole pins Connect the coloured light module to the spacers with the 3 mounting screws Mounting of coloured light module Fig 10 mounting screws ...

Page 6: ...e appropriate socket at the mainboard see fig 6 Install the clamp plate Reinstall the clamp plate It must be catched into the 4 pins of the plug Fig 11 pins Fig 12 masked Impress the safety spinner Impress tight fit the both safety spinners again À Á Fig 13 ...