11
EN
Fig. 2
Fig. 1
Installation
Screw the two fixation screws into the cabin wall
at the designated installation place according to
fig. 1. Make sure to leave a 6 mm gap between
screw head and wall surface (Fig 2). Now hang
the supplementary vaporiser through the two
upper holes on these screws and tigthen them
to secure the device (Fig. 3).
Dear customer,
You have purchased a high quality device which
willallow you to greatly enhance your experience
with your infrared warming cabin. Please read
this manual carefully before using the supple-
mentary evaporator.
Delivery scope
1 supplementary vaporiser
2 fastening screws
1 securing screw
Important notes
If assembled incorrectly, the system
will present a fire hazard. Please read
this installation guide thoroughly. It is
especially important to consider applica-
ble dimensions and observe the following
instructions:
•
This device has not been designed for
being used by persons (including children)
that are physically or mentally handicap-
ped or have sensory disabilities. Moreover,
it is not allowed to use this device without
sufficient experience and/or knowledge,
unless these persons will be supervised by
persons responsible for their security or in
case they have been instructed how to use
this device.
•
Children are to be supervised in order to
make sure that they do not play with this
device.
•
Make certain that no objects have
been placed on the vaporiser unit before
each start-up.
•
Caution:
High temperatures on the
vaporiser unit during operation can cause
burns on contact.
•
The vaporiser unit is not intended for in-
stallation or placement in a niche under
the bench or under a roof slope.
•
Caution:
For infrared cabins with in-
frared mats, please pay attention that the
attached mounting screws will not damage
the mats. Ask your cabin manufacturer.
•
Caution:
Never mount the additional
vaporiser on the outside IR-cabin directly
below an infrared heater.
Minimum lateral distance
to the cabin walls: 4 cm
6 mm
21 cm
70 - 75 cm
