72
Operating Instructions - InfraStyle / InfraStyle i
Service settings
EN
3
Set the value and confirm.
A value between 0 and 240 minutes can be selected in 30 minute-
increments. The ECO function starts if ECO mode is activated in the
main menu or by pressing the push button that is available as an
option.
See 4.5.8 Switching ECO mode on/off,
If the setting is 0 minutes, you must manually switch the ECO runtime
on or off in the main menu or by pressing a push button.
5.2 Defining the light source manually
The control panel is set to inductive loads by the factory so that resistive
loads can also be controlled by the control panel. If required, the light out-
put can also be manually set to capacitive loads.
If light bulbs are used, the load for lighting must remain as an inductive
load.
The current setting is shown on the display.
09:15
ECO
Setting
ECO Time
240min
Display symbol
Setting
Code
Inductive/resistive load (lighting for phase con-
trol),
if light bulbs are used.
Factory setting
8001
Capacitive load (lighting for phase control)
Electrical ballasts for phase-cut dimmer
8002
R,L
R,C
