InfraStyle / InfraStyle i - Operating Instructions
79
Service settings
2
Switch the off switch on the relay box to I.
The progress of the update is displayed on the panel. The control unit
restarts automatically once the update is complete.
The update was not successful if there is no icon after the relay box
switches back on or if the software crashes during operation.
See
Repeating the update if unsuccessful,
3
Remove the memory card after the update.
4
Place the front panel directly in front of the housing.
Ensure that it is aligned properly. The S-Bus connection must face
downward.
Position the connecting cable in the bottom piece so that it is not
pinched.
5
Press the front panel carefully with a consistent amount of pressure into
the housing until it audibly snaps into place.
Repeating the update if unsuccessful
1
Load the old software version onto the card.
2
Perform the steps as described in
3
Repeat the update once the old software version has been restored.