12
13
Selection: - Low
- Mid
(
default setting
)
- High
F2.5 Filter
F2.5.1 Filtering
F2.5.2 Motion Range
Selection:
0.5d(default setting), 1d, 3d
F2.10 Reset
This Reset will not reset Metrology, Scale build, GEO value.
This function is available only when F4.1.1 is set as On
Selection:0…99s
(
5 is default setting
)
(0 = the backlight will not time out)
After the back light time out, the back light could be
activated by pressing any key
11.3.3. F4 Function block Terminal
F4.1 Display
F4.1.1 - Backlight
Selection:
On/Off (Off is default setting)
F4.1.2 Backlight Timeout
F4.2 Auto Power Off
F4.2.1 Auto Power Off
Selection:
On/Off (Off is default setting)
F4.2.2 Auto Power off Timeout
Selection:
1…60minutes
F4.3 Terminal Sleeping
F4.3.1 Terminal Sleeping
Selection:
On/Off (Off is default setting)
F4.3.2 Terminal Sleeping Timeout
Selection:
30s, 60s, 90s
F4.10 - Reset
- Auto Print
- Single-line
11.3.4. F5 Function Block Com
F5.1 Connection
Selection:
- Print(default setting)
F5.2 Format
F5.2.1 - Line Format
Selection:
- Multi-line (default setting)
F5.2.2 Add Line Feed
Selection:
0…9(3 is default setting)
F5.2.3 Auto Print Threshold
If F5.1 selects auto print, the print threshold should set.
Selection:
0…FS(10d is default setting)
F5.2.4 Auto Print reset threshold
If F5.1 selects auto print, the print reset threshold should set
Selection:
0…FS(10d is default setting)
F5.3 Com1
F5.3.1 Baud rate
- 7 even
- 8 none
(
default setting
)
- 7 odd
Selection: - 1200
- 2400
- 4800
- 9600
(
default setting
)
- 19200
F5.3.2 Bits / Parity
Selection:
F5.3.3 Flow Control
Selection:
On/Off (Off is default setting)
F5.3.4 Checksum
Selection:
On/Off (Off is default setting)